LayerGlance
← Back to productsSCREEN & LIGHTS SETUP

Plug in. Pick your product. Install.

Connect your supported board by USB and open this page in desktop Chrome or Edge. No coding or specialist software needed. Choose a fresh install for a new board, or update an existing setup and keep its settings.

  1. 01Plug inUSB data cable
  2. 02InstallDesktop Chrome or Edge
  3. 03ConnectWi-Fi + local printer
YOUR FREE LICENCE

Sign in once to register this controller. Free costs nothing; your account keeps installations and future upgrades together.

01 · FIRMWARE

Controller: Waveshare ESP32-S3-Zero with 4 MB flash.

02 · INSTALL TYPE

Use for a first install or recovery. Choosing erase in the installer removes Wi-Fi, printers, settings, optional device password, and the installed license.

Use desktop Chrome or Microsoft Edge

Safari and Firefox do not expose the Web Serial connection required for flashing.

  1. Disconnect external power and connect only the controller by USB.
  2. Click Connect, then select its ESP32-S3 serial port.
  3. The installer checks the ESP32 family and flash capacity before any erase or write and stops on the other product's controller.
  4. Keep USB connected until the installer reports success.

Board not listed, or the connection fails? Hold BOOT, tap RESET (or plug the board in while holding BOOT), release BOOT, then try again.

Your Free licence records this controller's Device ID, product, firmware and installation date/time in your account. A reported USB write does not confirm a successful boot. Wi-Fi passwords, settings and printer access codes are not uploaded. Privacy details.

After a full install, keep USB connected. In the installer choose Next, then Logs & Console, press RESET once, and record the “Setup WiFi password” shown there. Keep it private, join the setup Wi-Fi whose name starts with “LayerGlance-Glow-”, then open http://192.168.4.1/wifi to enter your normal Wi-Fi.

Install firmware · LayerGlance